top of page
ProWash and Dry - SprintRay

ProWash and Dry - SprintRay

Pro Wash and Dry - Sprintray
SprintRay Pro Wash/Dry is the first fully-automated, two-stage wash and dry system built to deliver the speed, cleanliness, and ease-of-use demanded by the modern 3D printing dental clinic.

  • Fast - Mechanical jettingwashes your parts injust 10 minutes.
  • Easy - Simple touch screen controls deliver a superior wash experience.
  • Clean - Automatic pumps make sure you never have to touch alcohol

 

Automated 2-Stage Wash & Dry:

  • Mechanical Jetting.

Using a high-speed motor that spins at over 10,000 RPM, Mechanical Jetting is a patented system that rapidly delivers agitated alcohol to 3D printed parts with only 500mL of solvent.

  • 10-minute Wash Cycle

Thanks to the efficiencies gained through MechanicalJetting, SprintRay Pro Wash/Dry can complete a full, two-stage wash cycle in just ten minutes.

  • Set it and Forget it

Place the SprintRay build platform or included wash basket in the wash cradle and press ‘Start.’ Pro Wash/Dry automatically performs a two-stage wash and dry.

 

Easy Solvent Management

  • Science Removes the Guesswork

Precalibrated hydrometers sink in clean IPA and float when it’s dirty.
Since you always know when it’s time to replace IPA, your parts will
always come out clean.

  • Efficiency to Write Home About

Pro Wash/Dry can operate with a half-liter of alcohol and recycle from one chamber to another with a single touch.

  • Quick-connect IPA Draining

Snap the hose into place, creating a water-tight seal to drain IPA in
a way that is clean, efficient, and safe.

 

Specification

  • Platform Wash Envelope : 17 x 12.7 x 7.6 cm 7 x 5 x 3 in

  • Liquid Level Monitoring System : Conductive Sensor

  • Wash Liquid Compatibility : 
    - Isopropyl alcohol 91% (Recommended)
    - Isopropyl alcohol 99%
    - Ethanol 
  • Wash Liquid Capacity : 2 liters per reservoir

  • User Controls : 3.5" color touch-screen Pre-defined Wash/Dry preset

  • Safety Sensors
    - Automatic Start/Stop Sensors
    - Platform vs Basket Detection
    - Fill Level Sensor

  • Dimensions : 30 x 30 x 46 cm 12 x 12 x 18 in

  • Basket Wash Envelope :
    - 17 x 12.7 x 12.7 cm
    - 7 x 5 x 5 in

  • Liquid Saturation Monitoring System : 2 Pre-calibrated Hydrometers

  • Liquid Disposal Method

    - 2 Standard Quick Connect Drain Ports
    - 1 Quick Connect Drain Hose with
    -  Automatic Cut-off

  • Minimum Wash Solution Required 

    - 500 mL Per Reservoir

  • System Controls :  Microcontroller with upgradable firmware via USB

  • Power Requirement : 100–240v (Via DC Adapter)

  • Packaging Dimensions

    - 36 x 36 x 50 cm
    - 14 x 14 x 20 in
     

Documentation
Brochure

Video:

    Related Products

    bottom of page